Goodman’s Direct Comfort Packaged Heat Pump Provides All‐in‐One Space & Energy‐Saving Solution
Your home is your castle and space is precious. A Goodman’s Direct Comfort packaged heat pump keeps you comfortable inside while all of the equipment stays outside. An ideal choice for homes or buildings where it’s not possible or desirable to locate heating and cooling components indoors, these self‐contained units install outside at ground level or on the roof.
What’s more, choosing Goodman’s Direct Comfort DC‐GPH1424M41 packaged heat pump with ECM (Electronically Commutated Motor) technology can lower your energy bill by up to 49% if you are replacing older conventional HVAC.
- Guaranteed energy savings with ECM plus heat pump technology
- 14 SEER, 8 HSPF
- Fully charged system
DC‐GPH1424M41 | Packaged Heat Pump
Just like the name points out, the Goodman’s Direct Comfort packaged heat pump is all‐in‐one, with the compressor, blower and evaporator and condenser coils in the same cabinet. Energy‐efficient heating and cooling is achieved through reverse cycle heat pump technology. For extremely cold regions, auxiliary/emergency heat kits are available as field‐installed units.
The 5‐speed ECM blower motor automatically shifts through the 5 speeds to regulate the flow of conditioned air into your space. Since speed adjustments are gradual and constant, the temperature remains steady at the thermostat setting. This is in stark contrast to the fluctuating room temperatures created by standard on/off systems.
We’ve all experienced the frustrating temperature swings of conventional 1‐speed units. As soon as the set temperature is met, the system turns off and the “comfort zone” begins to drift away. Over the next 12 minutes – the average on/off cycle – the room becomes too hot or too cold, depending on the season. Relief is only delivered once the motor turns on again or you get fed up and change the thermostat setting.
In addition to the energy savings and balanced room temperature, ECM also provides superior humidity control. By neither heating nor cooling too fast like a standard HVAC, the ECM keeps air moisture at comfortable relative humidity of 50%.
Even though the packaged unit is meant for outside storage and not inside where space is more limited, it is still compactly designed for a smaller footprint and operational noise is contained by a fully‐insulated blower compartment. Extra care is also taken to weatherize the entire unit. The galvanized steel cabinet is powder painted architectural gray and resists fading and corrosion. It features an enclosed and permanently lubricated condenser fan motor and steel louver coil guards.
- Superior humidity control
- 8 HSPF
- Combined unit makes maintenance easier
- Easy access to blower compartment panel
- All‐aluminum evaporator coil
- Copper tube/aluminum fin coil
- Quiet horizontal discharge
- Auxiliary electric heat kits available as field‐installed options
- Meets California low‐NOx emissions requirements
- Cabinet air leakage less than 2.0% at 1.0 inch H2O when tested in accordance with ASHRAE standard 193
- Cabinet air leakage less than 1.4% at 0.5 inch H2O when tested in accordance with ASHRAE standard 193
- AHRI Certified
- ETL Listed
What’s IncludedYour Goodman’s Direct Comfort DC‐GPH1424M41 Packaged Heat Pump from Heat & Cool Comes With:
- DC‐GPH1424M41 | Packaged Heat Pump
- Installation Manual
- Technical Specification
- Manufacturer Warranty
- 10‐year parts limited warranty
Brand Direct Comfort Model Number DC-GPH1424M41 Heating Capacity 23000 Btu/h Heating Efficiency (HSPF) 8 Cooling Capacity 24000 Btu/h Efficiency (SEER) 14 Compressor Stages 1 Blower Motor Multi Speed ECM Blower Motor Capacity (Nominal) 850 cfm Configuration Horizontal Left or Right/Downflow Min. Circuit Ampacity 21.8 amp Unit Width 47 In Unit Depth 51 In Unit Height 32.75 In Manufacturer Compressor Limited Warranty 10 Years Manufacturer Parts Limited Warranty 10 Years
- Technical Specs
Brand Direct Comfort Model Number DC-GPH1424M41 Heating Source Type Heat Pump Heating Capacity 23000 Btu/h Heating Efficiency (HSPF) 8 Cooling Capacity 24000 Btu/h Efficiency (SEER) 14 Compressor Stages 1 Blower Motor Multi Speed ECM Blower Motor Capacity (Nominal) 850 cfm Configuration Horizontal Left or Right/Downflow Min. Circuit Ampacity 21.8 amp MOP (Maximum Overcurrent Protection-Breaker) 30 Amp Unit Width 47 In Unit Depth 51 In Unit Height 32.75 In Manufacturer Compressor Limited Warranty 10 Years Manufacturer Parts Limited Warranty 10 Years Compressor Type Scroll Sound Level 76 dB Installation Type Central Ducted Electrical 208-230 V, 1 Phase, 60 Hz Return Plenum Dimension (Downflow) 22" W x 11" L Supply Plenum Dimension (Downflow) 11" W x 22" L Return Plenum Dimension (Horizontal) 16" W x 16" H Supply Plenum Dimension (Horizontal) 16" W x 16" H Shipping Weight 380 lbs
Write Your Own Review